Acer AT350 F3 사용자 설명서 - 페이지 10

{카테고리_이름} Acer AT350 F3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AT350 F3 24 페이지.

Initial system startup problems

Problems that occur at initial system startup are usually caused by an incorrect installation

or configuration. Hardware failure is a less possible cause. If the problem you are

experiencing is with a specific application.

Initial troubleshooting checklist

AC power is available at the wall outlet?

⚫

Is the power supply module properly installed?

⚫

Is the system power cord properly plugged into the power supply module socket? and

connected to a NEMA 5-15R outlet for 100-120 V or a NEMA 6-15R outlet for 200-240

Are all peripheral cables correctly connected and secured?

⚫

Did you press the system power button to turn the server on (power on indicator should

be lit green)?

⚫

Are all device drivers properly installed?

⚫

Are hard disk drive(s) properly formatted and configured?

Are the BIOS configuration settings in the BIOS Setup Utility correct?

⚫

Is the operating system properly loaded?

Refer to the operating system documentation.

⚫

Are all hardware components compliant with the tested components

⚫

lists?

Are all internal cables correctly connected and secured?

⚫

Is the processor properly seated in its mainboard socket?

⚫

Are all standoffs in the proper location and not touching any components, causing a

potential short?

⚫

Are all add-in expansion cards fully seated in their mainboard slots?

Are all system jumpers correctly set?

⚫

Are all switch settings on add-in boards and peripheral devices correct?

To check these settings, refer to the manufacturer's documentation that comes with

them. If applicable, ensure that there are no conflicts (e.g., two add-in boards sharing

the same interrupt).