Apollo Spas Saturn 소유자 매뉴얼 - 페이지 3
{카테고리_이름} Apollo Spas Saturn에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Spas Saturn 20 페이지.
- 1. Table of Contents
- 2. Important Safety Instructions
- 3. Placement Information & Access
- 4. Spa Specifications
- 5. Electrical Specifications
- 6. Electrical Instructions
- 7. Start up Instructions
- 8. Draining the Water
- 9. Spa Care & Maintenance
- 9. Filtration System
- 9. Care of the Spa Cover
- 9. Vacation Care Instructions
- 9. Winterizing Your Spa
- 10. Water Maintenance
- 11. Troubleshooting
Important Safety Instructions:
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
When installing and using this electrical equipment, basic safety precautions should
always be followed, including:
1) WARNING:
To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all
times.
2) WARNING:
A grounding wire connector is provided on this unit to connect a minimum No. 6 AWG solid copper conductor
between this unit and any metal equipment, metal enclosures of electrical equipment, metal water pipe, or conduit within 5
feet of the unit.
3) DANGER:
Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by children. To
avoid accidents, ensure that children cannot use this hot tub unless they are supervised at all times.
4) DANGER:
Risk of Injury. The suction fittings in this hot tub are sized to match the specific water flow created by the pump.
Should the need arise to replace the suction fittings or the pump, be sure that the flow rates are compatible. Never operate the
hot tub if the suction fittings are broken or missing. Consult your local dealer for assistance in choosing an appropriate replace-
ment suction fitting.
5) DANGER:
Risk of Electric Shock. Install at least 5 feet, from all metal surfaces. As an alternative, a hot tub may be
installed within 5 feet of metal surfaces if each metal surface is permanently connected (bonded) by a minimum No.
6 AWG solid copper conductor attached to the wire connector on the grounding lug, inside the equipment compartment on
the equipment box.
IMPORTANT!
This manual was
written to ensure
the proper use and
installation of any
Apollo Spa. Any
modifications to the
procedures outlined
may result in
your warranty
being voided.
Please read this
manual to avoid any
unnecessary damage
to your spa and
equipment.
6) DANGER:
Risk of Electric Shock. Do not permit any electrical appliance, such as a light, telephone,
radio, television, etc. within 5 feet (1.5 m) of a hot tub.
7) ELECTRICAL
SUPPLY:
breaker to open all ungrounded supply conductors. The disconnect must be readily accessible and
visible to the hot tub occupant but installed at least 5 feet from the hot tub water.
8) WARNING:
To Reduce the Risk of Injury:
a)
The water in a hot tub should never exceed 104 ° F. Water temperatures between 100°F
and 104°F are considered safe for a healthy adult. Lower water temperatures are
recommended for young children and when hot tub use exceeds 10 minutes.
b)
Since excessive water temperatures have a high potential for causing fetal damage during the early
months of pregnancy, pregnant or possibly pregnant women should limit hot tub water temperatures
to 100°F. If pregnant, please consult your physician before using a hot tub.
c)
The use of alcohol, drugs, or medication before or during hot tub use may lead to unconsciousness
with the possibility of drowning.
d)
Persons suffering from obesity or a medical history of heart disease, low or high blood pressure,
circulatory system problems, or diabetes should consult a physician before using a hot tub.
e)
Persons using medication should consult a physician before using a hot tub since some medication
may induce drowsiness, while other medication may affect heart rate, blood pressure, and circulation.
9)
A bonding lug bar is provided on the side of your spa pack to accommodate grounding of entire
spa. To reduce the risk of electric shock, connect the local common bonding grid in the area of the
hot tub to these terminals with an insulated or bare copper conductor not smaller than No. 6 AWG
solid copper conductor.
10)
All field-installed metal components such as rails, ladders, drains or other similar hardware
within 10 feet of the hot tub shall be bonded to the equipment grounding bus with
copper conductors not smaller than No. 6 AWG solid copper conductor.
11)
Use the hot tub straps and clip tie downs to secure the cover when not in use. This will
help to discourage unsupervised children from entering the hot tub. There is no representation
that the cover, clip tie downs, or actual locks will prevent access to the hot tub.
The electrical supply for this product must include a suitable circuit
2