Apollo Spas Triton 소유자 매뉴얼 - 페이지 18
{카테고리_이름} Apollo Spas Triton에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Spas Triton 20 페이지.
페이지 인쇄- 1. Table of Contents
- 2. Important Safety Instructions
- 3. Placement Information & Access
- 4. Spa Specifications
- 5. Electrical Specifications
- 6. Electrical Instructions
- 7. Start up Instructions
- 8. Draining the Water
- 9. Spa Care & Maintenance
- 9. Filtration System
- 9. Care of the Spa Cover
- 9. Vacation Care Instructions
- 9. Winterizing Your Spa
- 10. Water Maintenance
- 11. Troubleshooting
Common Spa Water Problems~Cause & Remedy
PROBLEM
POSSIBLE CAUSES
A. Poor Filtration
B. Suspended particles
C. Organic contaminants build up
D. pH high
CLOUDY
WATER
E. Total alkalinity high
F. Combined chlorine in
the water
G. High dissolved solids
H. Hardness too high
A. Dissolved metals from
water source
COLOURED
WATER
B. Low chlorine/bromine levels
C. Fragrance
A. High concentration of oils and
FOAMING
organics being agitated by
the jets and/or Therapy Air
SCALE
A. High Calcium level, high
DEPOSITS
pH, high alkalinity
A. High level of organic
ODOR
contaminants, combined
with chlorine
A. pH too low
B. Combined chlorine due to high
EYE/SkIN
concentration of organic
contaminants
IRRITATION
C. Allergic reaction to sanitizer
D. Bacterial contamination
NO
A. High concentration of contaminants
CHLORINE/
using up sanitizers
BROMINE
B. Test kit reagents ineffective
READING
SOLUTIONS
A. Dirty filter, clean with Apollo Spas Filter Clean
(not with disposable filter).
B. Add Apollo Spas Clarifier
C. Shock treatment with Apollo Spas Spa Oxidizing Shock
D. Add Apollo Spas pH Down until level reads 7.2-7.6
E. Add Apollo Spas pH Down to adjust TA level to
100-130 ppm
F. Shock treatment until combined chlorine is
eliminated (see container instructions)
G. Empty spa and refill
H. Add Apollo Spas Stain & Scale until level reads
100-280 ppm
®
A. Use Arctic Pure
Best Defense and have your
dealer check your water balance
B. Add Apollo Spas Chlorinating Granules
treatment to raise chlorine
levels and test chlorine levels or for Bromine system
add Spa Chlorinating Granules & test Bromine levels
C. Stop the use of fragrance
A. Squirt Apollo Spas Defoamer on foam.
Refer to pg 20 for more information.
(not with disposable filter).
A. Drain partially, add Apollo Spas Stain & Scale,
correct pH level to 7.2 - 7.6 and alkalinity to 100-
130 ppm.
A. Check pH and adjust as required.
B. Shock with Apollo Spas Spa Oxidizing Shock, add
Chlorinating Granules or Spa Chlorinating Granules
(dependent on whether you have a chlorine or bromine
system)
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Add Apollo Spas pH Up until level reads 7.2-7.6 ppm
B. Add Apollo Spas Spa Oxidizing Shock, add
Chlorinating Granules or Spa Chlorinating Granules.
C. Change from Bromine to Chlorine or vice versa.
D. Drain and refill spa.
A. Add sanitizers until levels are up to the recommended
levels
B. Replace test kits at least once a year
C. Chlorine/Bromine level very high and is bleaching
test reagent, Allow sanitizer levels to recede by
opening cover and running jets.
17