Apollo Sprayers T6000 사용 설명서 - 페이지 4

{카테고리_이름} Apollo Sprayers T6000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Sprayers T6000 11 페이지. Mist applicator

• Tipping the Mist applicator causes the Mist applicator to clog. Dried spray material also clogs the pressure

delivery tube and fittings. The Mist applicator does not function when clogging occurs.

• When not in use, be sure to disconnect the hose and place the Mist applicator into the holder in the turbine to

avoid tipping.

GROUNDING INSTRUCTIONS

This product must be properly grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical

shock by providing an alternate path for the electrical current.

This product is equipped with a cord that has a ground wire and an appropriate ground plug. Plug the unit into an outlet

IMPROPER INSTALLATION OF THE GROUND PLUG CAN RESULT IN THE RISK OF

ELECTRICAL SHOCK. IF REPAIR OR REPLACEMENT OF THE PLUG OR CORD IS

NECESSARY, DO NOT CONNECT THE GROUND WIRE TO EITHER FLAT BLADE TERMINAL.

THE WIRE WITH GREEN INSULATION (WITH OR WITHOUT A YELLOW STRIPE) IS THE

GROUNDING WIRE.

1. For any question regarding proper installation of the ground plug, consult a qualified

(licensed or certified) electrician.

2. Do not modify the plug provided. If the plug does not fit the outlet, have the proper

outlet installed by a qualified electrician.

3. This product is for use on a nominal 120-volt circuit and has a grounding plug that

looks like the plug in Figure 2. Make sure that the product is connected to an outlet

having the same configuration as the plug. No adapters should be used with this

product.

4. If an extension cord is required, use only a three wire extension cord that has the

same configuration as the unit cord, including the (round) ground terminal. Make

sure that the extension cord is plugged into a properly grounded receptacle.

5. When using an extension cord, be sure it is in good condition and heavy enough to

meet the specifications in the chart below. If an extension cord is needed the

following wire sizes must be used.

6. (See Chart 1) Figure 2

General Safety Information cont'd.:

that is properly installed and grounded in accordance with local codes and ordinances.

25' cord.................................10, 12, or 14 Gauge

50' cord.......................................10 or 12 Gauge

100' cord.............................................10 Gauge

Chart 1 Extension Cord Requirements