4DRC 4D-F10 사용 설명서 - 페이지 14

{카테고리_이름} 4DRC 4D-F10에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4DRC 4D-F10 16 페이지.

Runaway return: When the signal of the remote controller is interrupted for

about 4s, the aircraft will automatically return to the place where there is a

Warning

signal and stop. Low battery return: when the aircraft is in low battery electricity,

it will forcefully return to a place that is 20m above the take-off point. The return

flight cannot be cancelled during the low battery return.

13.3 Speed switching

When the aircraft takes off, it is by default in the low-speed mode (3-geared switching);

gently press the remote control by a "beep" sound for low-speed gear, two "beep" sounds for

medium-speed gear, and three "beep" sounds for high-speed gear (Figure 17)".

APP operation: Click the "More Functions" icon (Figure 18) in the APP control interface, and

the flight speed can also be switched (Figure 19).

Figure 17

13.4 Waypoint flight mode

① In GPS mode, click the "More Functions" icon (Figure 20) in the APP control interface to

enter the multi-point flight (Figure 21). At this time, the interface changes from the image

transmission page to the map page. On the map page, click to set the track range of the

segmented waypoints or continuous waypoints (Figure 22). During the setting, if the track

waypoints are too dense, you can click the delete icon to delete all the waypoints (Figure 23).

② After setting of the waypoint, click the send icon (Figure 24), the aircraft will fly to all

waypoints from the initial point to complete the preset flight trajectory. The direction of the

aircraft can be controlled by the joystick during the flight.

Figure 20

Figure 23

Figure 29

Figure 18

Figure 21

Figure 24

Figure 30

Figure 19

Figure 22