App-Tek OdaLog Surface-Mount Antenna 설치 매뉴얼 - 페이지 3

{카테고리_이름} App-Tek OdaLog Surface-Mount Antenna에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. App-Tek OdaLog Surface-Mount Antenna 4 페이지.

5. Megapoxy™ kit (2 part epoxy) - Preparation and Fitment:

Ensure all safety guidelines are observed when using the provided two-part epoxy

(Megapoxy™ 36 Gun Grade). Read the Caution Notice and Technical Bulletin

provided in this kit, refer to the manufacturers material safety data sheet for

further information (MSDS available on request from distributor). Latex or PVC

gloves (provided) are recommended for this process (not nitrile).

The antenna wire must be inserted through drilled hole before pouring epoxy.

Once mixed, epoxy will begin to set very quickly (approx 2-3min), ensure all

steps have been completed, and antenna is ready for mounting prior to mixing.

a. Empty contents of both syringes (Black & White) into a cup (Note: that

some plastics may melt).

b. Using a mixing stick, stir until the colour consistency reaches a dark grey

(no white swirls) – mixing should take no more than 20sec.

6. Ready to pour:

Make sure the antenna wire with connector is inserted through the hole before pouring

epoxy. Stand the antenna off to the side, so allow the pouring of the epoxy, as shown.

Begin pouring the epoxy in the centre of the mounting area, and spread over the

mounting area quickly. On a flat surface, you may not require the entire mixed

contents.

7. Placing the antenna:

Gently push the antenna wire though the hole, and allow the antenna to float on the

pool of epoxy. Applying pressure to the top face of the antenna, gently reposition if

required. If suitable, you may wish to pull gently on the antenna wire from the

underside of the surface to ensure the wire lines up correctly with the drilled hole.

Once satisfied with location, apply even pressure to the top surface until the epoxy

squeezes out past each edge/corner of the antenna, being sure not to squeeze all of the

epoxy out (needs to be an epoxy thickness 1-2mm to function correctly).

10-2003, OdaLog Surface-Mount Antenna Installation Guide

WARNING

IMPORTANT

Revision: 1 ,

31/05/2010