Duren 521805 사용 설명서 - 페이지 4

{카테고리_이름} Duren 521805에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Duren 521805 9 페이지. Conventional gravity gun

페이지 인쇄

FMT3006

521805

Instruction Manual

medication.

Do not spray at or near and naked flame or any source of ignition.

DO NOT spray any material without first consulting a Material Safety Data Sheet. If one

is not available it is advised that you source an alternative material.

Be aware of the dangers of working in or on and building or material containing asbestos.

Always take a appropriate measures up to an including contracting licensed 3rd parties

to remove and/or make safe any asbestos.

If the material sprayed makes contact with eyes, skin or enters the respiratory system

take appropriate measures as advised by the HSE and your own Health and Safety

guidelines. If in doubt, seek medical help.

NEVER point air supply hose at yourself or others.

Be aware of the dangers and hazards of spraying isocyanate based paints.

Operating Instructions

Preparation

To obtain the best results, it is important that you prepare the surface to be sprayed and thin the

paint to the correct viscosity before you start work. Always ensure that the surface to be sprayed is

free from dust, dirt, grease and other foreign bodies. Always mask the areas around the areas to

be sprayed using good quality masking tape. The paint to be sprayed should be suited to the task

and compatible with your spraygun. There should be no lumps or other particles. Make sure that

you have a properly working strainer. Many substances can be sprayed with this gun buy it is im-

portant that you check with your paint supplier before purchasing your paint. It is very important

that you check the panel for signs of silicone contamination before starting work.

Thinning

Most paints are supplied ready for the type of application and applying technique but may have to

be thinned for use with your spraygun. Always follow the paint manufactures advice on thinning

paint. A viscosity cup will help you determine the correct viscosity of the paint to be used. To

measure the viscosity of the paint fill the cup to the brim and measure the length of time it take to

empty. The table below shows the recommended times for different materials. Please note that

this is intended as a guide only and you should advice from your paint supplier.

Plastic & Latex

Primers

Oil based paints

Aluminium paints

Wood sealers

Wood stains

If the paint takes longer than the recommended time to empty, further thinning is required. Mix a

small quantity of the appropriate thinner and use the viscosity cup again until the required figure is

achieved. Some paints contain lumps and particles and these should be strained before use.

Spraying

Fill the paint cup with the appropriately thinned paint and screw onto the gun. Connect the air hose

switch on compressor. See Fig.1 for the recommended air line setup It is recommended that you

use a test card or scrap panel to make sure that the paint is correct. This also aids comparison

with existing paint work.

To get best results, keep your spraygun level and at 90

Keep the nozzle 200-300mm from the surface and spray evenly from side to side or up and down.

Spraying at an angle will lead to paint runs. Use smooth, even strokes. When spraying large

T: 01582 661993 F: 01582 667100 E: [email protected]

24-28secs

18-22secs

22-25secs

28-35secs

Not required

Fast Mover Tools Limited

W: www.fastmovertoolsuk.com

Fast Mover Tools Limited

W: www.fastmovertoolsuk.com

Water based Paint

Varnishes

Enamel paints

Car underseal

Wood preservatives

to the surface at all times (see Fig.2).

20-25secs

18-22secs

25-35secs

Not required