Data Aire dap4 touch 프로토콜 매뉴얼 - 페이지 3

{카테고리_이름} Data Aire dap4 touch에 대한 프로토콜 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Aire dap4 touch 13 페이지. Modbus tcp/ip protocol integration
Data Aire dap4 touch에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지), 사용자 설명서 (8 페이지), 설치 지침 (2 페이지)

페이지 인쇄

I. Modbus TCP/IP - Setup Procedures for dap4 Ethernet Card

Note: When connecting to the Ethernet card, a crossover cable must be used

1. Configure BMS PORT 1 into "BACnet TCP IP" protocol in menu G: Network Config of the

dap4 controller.

2. All Ethernet cards were set up for a DHCP server. You must give the card its factory IP

address to access the card and then switch it to the Ethernet protocol.

3. To do a factory reboot of the card, shut of power to the dap4 controller. Next, press and hold

the button on the card. Now, power on the dap4 controller. Wait approximately 20 seconds

until the status LED begins to blink red 3 times slowly. After the first Red blink, release the

push button. After releasing the button, wait approximately 50 seconds and the card is now

able to be communicated to.

4. The default settings for the card are as follows.

IP address – 172.16.0.1

5. Once you have reset the Ethernet card, you must now configure your network card in your

PC to 172.16.0.*

* any value other then 1.

6. After your PC's network card is configured, open Internet Explorer and enter the card's IP

address (172.16.0.1.)

7. The following prompt will be displayed on your PC's Screen (user name – admin, password –

fadmin)

Data Aire's dap4 Modbus TCP/IP

Net Mask – 255.255.0.0

Document: 600‐000‐961 version 4.0

Device Inst - 77000