4EVAC 4E-FMWB 설치 및 사용자 설명서 - 페이지 9
{카테고리_이름} 4EVAC 4E-FMWB에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4EVAC 4E-FMWB 17 페이지.
페이지 인쇄Hacousto Holland bv
Industrieweg 87
2651BC Berkel & Rodenrijs
4E-FMWB installation and user guide
Device ID
The microphone station needs an ID setting in order to be properly recognized in the network and operate.
If the device ID is duplicated or set to a wrong value, the device will not receive the correct configuration
settings from the 4EVAC main unit. In this case the remote station will be stuck in its boot sequence and
remain non-operational.
The device ID is set by means of two rotary switches, which define the two-digit hexadecimal value of the
ID.
In order to check or set the Device ID, you must access the rotary switches on the back side of the unit:
1.
Open the housing
2.
Unmount the front plate from the mounting studs
3.
Pull the front plate out and turn around to get access to the internal PCB.
4. Identify the high-significant and low-significant rotary switches. The Device ID is a combination [HI
LO] of those two digits.
5.
Make sure the ID value exists in your configuration settings, relates to the right device type and is
not duplicated on another device. Allowed values: 01-FE
6.
Set the Device ID value according to the configuration settings of the 4EVAC system.
7.
Plug in the L-Net cable connecting the station with the 4EVAC main unit.
8.
Observe the boot sequence, after which the system should automatically enter normal operating
mode.
9.
Put the front plate back in its place and assemble.
10. Close the housing.
Page 9 of 17
4E-FMWB internal view: Device ID setting
Author:
DD