4EVAC LOOPDRIVE 4E-FIM-RC 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} 4EVAC LOOPDRIVE 4E-FIM-RC에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4EVAC LOOPDRIVE 4E-FIM-RC 2 페이지. Field remote control module

LOOPDRIVE

Lorem ipsum dolor

Field Remote Control Module - FIM-RC

The FIM-RC is equipped with clearly market connectors. The FIM-RC has a

Sitananita ametete, consecteturity adipisicing elit, sed do eiusmod tempor incididunt ut

LOOP -FEED and LOOP-RETURN connection that are not sensitive to

feeding direction. LOOP has a DC-carrier for charging and communication

purposes.  

Please observe correct connectivity: 

RED

= PHASE / PLUS 

BLUE

= ZERO / MINUS 

NOTE:

The T-Branch switching load is maximised to 2000W. . 

The OVERRIDE signal must be sent together with any emergency message.

The override pilots-tone must be: 20kHz / 5Vrms (by default)

The FIM-RC has two potential-free switching contacts that connect to third party

instrument or equipment. Using these triggering relay contacts, a local source

automatically overrides when emergency paging from the VACIE is applied or a

local instrument can be energised. The FIM-RC is equipped with a power

capacitor that is charged by the LDB and has enough capacity to operate at least

two emergency cycles without the need for re-charging. The LED indicator(s) on

the FIM-RC are ﬂashing with intervals to indicate quiescent or fault condition. The

FIM has two indicators that are related to the status of either LOOP-A or LOOP-B

side (Loop feed). Please refer to the User and Installation manual V01R01 for

detailed information on the various indications of these indicators.

Trigger threshold adjustment: 

Holding the reset button for 10-sec will force the FIM-RC in measurement state.

(Fast blinking) In this state it measures any HF signal on the line (>16kHz) and sets

it trigger threshold 2Vac above measured HF signal.  

Conﬁrmation of new setting: Alternate blinking of indicators BLUE (5s-Fast). 

Rejection of new setting: Alternate blinking of indicators: ORANGE (5s-Fast

Activation at Threshold: Alternate blinking of indicators BLUE Slow

WAGO-quick-ﬁt

The FIM is equipped with WAGO push-

terminals that accept up to 2,5 mm

installation cable. A special tool is provided to

quickly remove all three wires in one run.

(Release-tool is included)

Field

core