Data Connect DSP19.2FP 설치 지침 - 페이지 3
{카테고리_이름} Data Connect DSP19.2FP에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Connect DSP19.2FP 3 페이지. Fast poll modem
페이지 인쇄Installation Instructions for DSP19.2 Fast Poll
The installation instructs provide below are intended for the installation of
the field upgrade kits EN3-KIT-WB (for wall-mount) and EN3-KIT-DIN (for
DIN rail mounting). If your modems already come with the front and rear
"L-Shape" brackets attached, please skip the first 3 steps for replacing the
panels and go directly to install the modems on the wall or DIN rails
Installing the DIN Rail Mounting kit:
1.
Place the DSP19.2FP modem on a desk or table top with the bottom faced upward.
2.
Remove the rear panel by removing the 4 screws and replace it with the "L-Shape" rear panel
mounting bracket onto the end of the modem by aligning with the connectors of the modem board
3.
Remove the front panel by removing the 4 screws and replace it with the "L-Shape" front panel
mounting bracket onto the end of the modem, by aligning with the L.E.Ds and switch.
4.
Attached the two (2) DIN Mount Brackets onto the front and rear panel with the six (6) provided
screws.
5.
Install the modem onto the DIN rail bracket by pushing the clips firmly to latch onto the DIN rail.
DIN Mount Bracks(2)
Rear Panel
Front Panel
Philip Screws (6)