Appareo STRATUS ESG 파일럿 매뉴얼 - 페이지 5
{카테고리_이름} Appareo STRATUS ESG에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Appareo STRATUS ESG 13 페이지. Portable receiver connector plate
Appareo STRATUS ESG에 대해서도 마찬가지입니다: 설치 매뉴얼 (5 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
2.4.
Mode selection keys
The table below describes each transponder mode. These modes will
automatically transition for various phases of flight. Unless otherwise
instructed, no action is needed.
Mode
Off
PWR
Standby
Altitude
Ground
(none)
On
2.5.
FUNC key
Press the FUNC key or the arrow keys to switch from the default screen
to the Pressure Altitude screen, GPS screen, Flight ID screen, and
Brightness screen. These screens are described below.
Pressure Altitude screen: Displays the current pressure altitude. If no
valid altitude is detected or Stratus ES/ESG is in On mode, the altitude
field will be replaced by dashes.
GPS screen: Displays the aircraft's GPS position in degrees latitude and
longitude. If no GPS signal is being received, the latitude and longitude
fields will be replaced by dashes.
Key
Stratus ES/ESG is powered off.
Stratus ES/ESG is powered on and does not send
SBY
responses to any ATC interrogations.
Stratus ES/ESG is powered on and responds to all
ALT
Mode A/C/S interrogations. Altitude is reported.
Stratus ES/ESG is powered on and in ALT or On
mode, but does not report altitude. Ground mode is
automatically detected. Press the ALT or ON key to
override Ground mode. Press SBY to remove this
override.
Stratus ES/ESG is powered on and responds to all
Mode A/C/S interrogations, but altitude reporting is
ON
suppressed.
Description
3