4EVAC Impact Controller-Expander 사용자 및 설치 설명서 - 페이지 7

{카테고리_이름} 4EVAC Impact Controller-Expander에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4EVAC Impact Controller-Expander 10 페이지.

Hacousto Holland bv

Industrieweg 87

2651BC Berkel & Rodenrijs

Impact Controller – Expander

User and installation manual

Micro SD card

The Controller-Expander is supplied with a pre-installed micro SD memory card. The memory card contains

the complete system configuration file.

The configuration file is prepared in the 4EVAC Manager – a Windows GUI application. More information

about creating configuration settings can be found in the 4EVAC Manager User Manual.

The memory card is under constant surveillance, as well as its contents. When the memory card is removed,

damaged or its contents are corrupted, the Controller will report a system fault. During the system fault

caused by a memory error, the Controller enters a safe state where the system stops all functions and

requires a reboot. This state can be reset only by a manual device reset.

Press it to trigger a hard reset of the Expander (different from RESET button on front panel – soft reset)

The Controller-Expander remains a G-Net device and as such can be supplemented with max. 16 L-Net

devices, which will be local slaves of this Controller-Expander.

The Controller-Expander (in comparison to Impact Controller) requires no local configuration settings,

except an ID / name / priority.

In the 4EVAC Manager configuration software, it is not possible to add a Controller-Expander without

having at least one G-Net device in the configuration first, i.e.:

Impact Controller

Compact 500.

The 4EVAC network features a full duplex RS-422 data link and 24V DC power to remote devices.

If you're building a distributed system using the 4EVAC network, you should make physical links between

devices using the right cables. Cabling should meet the following requirements:

Crossover twisted-pair cable (compatible with Ethernet crossover)

Page 7 of 10

Author: