Durite 0-441-10 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Durite 0-441-10에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Durite 0-441-10 4 페이지. Led high intensity warning light x 2 on mounting plate

6. Use only soap and water to clean the outer lens. Use of other chemicals could result in

premature lens cracking (crazing) and discoloration. Lenses in this condition have signifi-

cantly reduced effectiveness. Inspect and operate this product regularly to confirm its prop-

er operation and mounting condition. Do not use a pressure washer to clean this product.

7. It is recommended that these instructions be stored in a safe place and referred to when

performing maintenance and/or reinstallation of this product.

8. For this product to operate at optimum efficiency, a good electrical connection to chassis

ground must be made. The recommended procedure requires the product ground wire to

be connected directly to the NEGATIVE (-) battery post.

MOUNTING

1. Place the unit against the mounting surface

2. Mark the areas where the mounting holes are to be drilled. Confirm that no vehicle parts

could be damaged by the drilling process.

3. Using a bit size for a no. 304 metal screw, drill two mounting holes, a 0.5" diameter. Wire

passage hole(s) must also be drilled. Thouroughly de-burr all hole(s).

4. Pass the wires through the hole(s) in the gasket and through the wire passage hole(s) in

the mounting surface. Fix the light head to the mounting surface.

DIMENSIONAL DRAWING

0-441-10-LEAF