Data Harvest EasySense Q 5 매뉴얼 - 페이지 9

{카테고리_이름} Data Harvest EasySense Q 5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Harvest EasySense Q 5 20 페이지.

페이지 인쇄

1. What's in the Box

When EasySense Q is in sleep mode the current value from the active sensors can be

viewed by pressing the yellow button

Whilst in EasyLog mode the samples taken, current

logging interval and the time started can be viewed

at any time by pressing the green enter

When the sample interval is greater than or equal to one second (after logging for

6 minutes), it is possible to download data from EasySense Q to a computer to check its

validity without interrupting the recording using the Collect remote data option in the

Sensing Science Graph program (see the manual that accompanies the Sensing

Science software).

Note: If you would prefer to record remotely for a specified time span then EasySense Q needs

to be setup to record using the remote record option in the Sensing Science Graph program (see

the manual that accompanies the Sensing Science software).

Timing

Used to setup and store simple time measurements from either one digital switch type

sensor connected to Input A or two connected to Input A and Input B. Switch type digital

sensors e.g. a light gates have two states, low (ON) or high (OFF). The time

measurement taken by EasySense Q is for an object at Input A or from an object

travelling from the sensor at Input A to the sensor at Input B. Upon completion of the

timing event the elapsed time will be displayed in milliseconds on the LCD screen (to 2

decimal places).

Connect the digital sensor/s to Input (1)A or Input (1)A and (2)B. If the display is

turned off, press the green triangle

EasySense Q.

Use the yellow arrow button

down until it is pointing at Timer.

Press the green triangle

Use the yellow arrow

pointing at either Timing A to B or Timing at A. Press

the green triangle

EasySense Q will be ready to start taking measurements.

When a signal change from the digital sensor/sensors is

received, the time taken for the signal change at Input

A or A to B will be displayed in milli seconds (ms) on the

LCD screen. EasySense Q will then be ready to take the

next measurement.

Press the red square

the green triangle (enter)

will be stored in a data set.

Note: During Timing mode, EasySense Q will stay awake and fully powered at all times.

button.

or yellow arrow button

to scroll the cursor

to select.

to scroll the cursor until it is

to select.

(stop) to finish or cancel any pending timing event. Press

to return to the main menu. The measurements taken

Sample Taken: 269

Interval: 500ms

01/05/04 09:16:31

to wake up

Meter

Snapshot

EasyLog

Timer

Set Timing Mode

Timing A to B

Timing at A

Timing A to B

Samples Taken: 4

542.85 ms