Data Harvest 1100 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Data Harvest 1100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Harvest 1100 8 페이지. Smart wireless temperature sensor

Status Light

No light

Blue flashing

White flashing

Green flashing

Orange/green flashing

To switch the Temperature sensor off: Press and hold down the On/Off switch for about 2 seconds

until the white light is lit solidly then release.

If not communicating with the EasySense2 software the sensor will puts itself to sleep after a period of about

one hour of inactivity (blue LED flashing).

Connecting the Smart Wireless Temperature sensor to a computer

Bluetooth users: Do

NOT pair devices

or devices will need to support Bluetooth Low Energy (BLE), for further information refer to the instructions provided for

the EasySense2 software.

Install the EasySense2 software, if it is not already on your computer. For details of how to install and

operate this app, please refer to the instructions provided for the EasySense2 software.

On the computer acting as the Controller (interface connected to the computer).

If connecting via USB:

Step 1: Connect the Temperature sensor to the computer's USB port using the USB cable supplied. The

computer will automatically detect a new device and install the drivers. The status light on the

Temperature sensor will flash white to show its charging.

Step 2: Open the EasySense2 app.

Lab Setup will open showing the Smart Temperature

sensor as connected (Devices icon green). The status

light on the Temperature sensor will flash green to

indicate a connection is established.

If connecting via Bluetooth:

Step 1: Switch the Temperature sensor On.

Step 2: Open the EasySense2 app.

Step 3: Lab Setup will open, select the red Devices

icon.

Step 4: Select to connect to the Temperature sensor (the

list will show the ID number printed on the sensor).

ID number

Indicates

Sensor is Off. Short press the On/Off switch

Sensor On and Bluetooth advertising

Charging via USB mains charger or USB port

Communication with the EasySense2 software (via USB or Bluetooth)

has been established

Recording data

(if paired the sensor will not be available to the EasySense2 software). Computers

Connect

Temperature Sensor