Appion TEZ 8 운영 매뉴얼 - 페이지 3

{카테고리_이름} Appion TEZ 8에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Appion TEZ 8 14 페이지. Two stage vacuum pump

Warnings and Safety Information

This machine is for use by trained and certified professionals only.

Always wear gloves and eye protection when using this machine or handling refrigerants.

Read all Material Safety Data Sheets (MSDS) for any compounds that you are likely to encounter.

Failure to do so could lead to injury or death. This equipment is not to be used with any combustible

or flammable materials, doing so could lead to injury or death.

To reduce the risk of fire, extension cords must be at least 12AWG and not longer than 15 ft. This

equipment should be used in areas with mechanical ventilation providing at least four air changes

per hour, or be located at least 18" above the floor. Do not use this equipment near any spilled

or open containers of gasoline or other flammable liquid.

Remove all refrigerant from the system before connecting the vacuum pump. Attempting to

evacuate the system while it is under high pressure may cause damage to the vacuum pump.

To reduce the risk of equipment damage or fire, do not leave the TEZ8 running while unattended.

Disconnect the TEZ8 from the power supply before any maintenance or service of the TEZ8 to

reduce the risk of electrical shock or injury.

Keep out of reach of children at all times.

Caution: Always use a grounded 3-prong outlet.

Caution: Always remove all refrigerant from the system before connecting the vacuum pump.

We recommend using the Appion G5Twin for this purpose. Equipment damage may

occur if the evacuation is started while the AC/R system is under high pressure.

Note: For the deepest final vacuum, ensure that all fittings and hose connections are properly

and tightly secured before beginning the evacuation process.

Note: Before beginning the evacuation process, verify that the Debris Monitor/Catch tube (located

in the right-front corner of the TEZ8) is free and clear of any debris or oil.

Install a fresh TEZOM oil cartridge into the front of the Appion TEZ8 Vacuum Pump before

using (See Page 5: Changing the Oil for further details).

Connect the pump to the system according to the AC/R manufacturer's guidelines.

A. Install a vacuum-rated ball valve or manifold between the system and the TEZ8 to

allow for isolation of the system at the end of the evacuation process.

If you are using a vacuum gauge, attach it to the access port on the system that is farthest

from the TEZ8.