AddSecure Edge VS5010 사용자 설명서 - 페이지 11

{카테고리_이름} AddSecure Edge VS5010에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AddSecure Edge VS5010 14 페이지. Connect intercom
AddSecure Edge VS5010에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지)

AddSecure Edge VS5010 사용자 설명서

12 Specifications

Ethernet
Standard
Connection
IP addressing
Fault detection
Wi-Fi
Standard
Connection
Fault detection
2G/3G/4G
Frequencies
Connection
Fault detection
IP
TCP ports (outbound)
Alarm Transmission Interfaces
Interface to ARC
Dial capture interface to voice
panel
Serial interfaces
PIN Inputs interface
Alarm protocols supported
Panel protocols supported
PDK-13010-v.6.0 Edge VS5010 and VS5051 User manual
specified by EU directive 2014/33 and the EN81 regulations. Before leaving
the site, you should obtain confirmation from the ARC that all is working
correctly.
Section
10/100 Base T with auto-negotiation, up to 100m
RJ45 socket for CAT5 cabling
Dynamic (DHCP) or fixed
Loss of Ethernet synchronization
IEEE 802.11 b/g/n
2.4GHz b/g/n with internal PCBA chip antenna
Loss of association/data
Penta band LTE (4G)
800/900/1800 MHz
2100/2600 MHz
Dual band UMTS (3G)
900/2100 MHz
Dual band GSM (2G)
900/1800 MHz
MMCX socket for antenna on PCBA. On VS5051 additional SMA
socket on the outside of the enclosure.
Loss of registration with network
53165 (Alarms and Polling), 51292 (Diagnostic and Reflashing),
10001 (Upload/Download)
Addsecure Connect
Two-wire interface via terminal block.
RS485, TTL (max 3 metres), RS232 (max 3 metres)
Maximum input voltage range 0V to +28V DC (max 3 metres)
Input "low" (alarm) threshold < 1V
Input "high" (restore) threshold > 2V
Internal pull-up impedance 10K to 3.3V supply
SIA (level 1 to 3) reference SIA DC-03-1990.01(R2003.10)
Contact ID reference SIA DC-05-1999.09
FF (Scancom)
Robofon (Dial capture only)
Telim (Dial capture only)
CESA (Dial capture only)
Details
page 11