AddSecure Edge VS5010 사용자 설명서 - 페이지 3
{카테고리_이름} AddSecure Edge VS5010에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AddSecure Edge VS5010 14 페이지. Connect intercom
AddSecure Edge VS5010에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지)
페이지 인쇄
1 About this manual
2 Target group
3 Presentation of the terminals
3.1 AddSecure Connect
PDK-13010-v.6.0 Edge VS5010 and VS5051 User manual
This manual provides a guide to the installation and maintenance of the
VS5010 and Edge VS5051 terminals.
This manual is intended to provide assistance to engineers installing and
maintaining the Edge VS5010 or Edge VS5051 terminals at customer sites.
Edge terminals, based on the successful range of AoIP Alarm over IP (AoIP)
terminals from AddSecure, offer a new concept in AoIP, providing cost
effective VoIP/AoIP for alarm systems. Both the Edge VS5010 and the Edge
VS5051 are based on the Edge VS5000 motherboard. This motherboard is a
fully equipped circuit board designed to fulfill the task of a Grade 4 Secured
Premises Transmitter (SPT) and meets all relevant standards for EN
compliance in intercom and elevator systems.
The two products based on the VS5000 motherboard are as follows:
Variant
VS5010
Is supplied without an enclosure and is intended to be installed in
existing enclosures of intercom and elevator applications.
VS5051
Is supplied in a metal enclosure with 20Hr battery backup for use
in elevator applications.
Polling and alarm transmission to the alarm receiving centre (ARC) are
performed using 2G/3G/4G, Ethernet or Wi-Fi communications via the
AddSecure Connect platform.
AddSecure Connect is a cloud-based platform that uses a secure private
LINK network via the on-board eSIM and does not require the installer to
add a SIM card. It provides secure and controlled alarm transmission for
fire, intruder, elevator, technical and other alarms. The platform simplifies
setting up terminals and complying with regulations for the installer, the
customer and alarm receiving centres.
Edge terminals are intelligently provisioned through AddSecure Connect.
AddSecure Connect is perfect for every situation where monitored
communication between a site and the ARC of choice is required, as well as
when there is a need for controlled remote access to an external device.
Add Secure Connect has many features, amongst other, the following:
Easy to switch ARC's when situation, alarm mix, or environment
changes.
Remote access for installers (analysis and setup) to save cost and time.
Different alarms routed to separate ARC's for flexible requirements
management.
One alarm routed to multiple ARCs
Application
page 3