DURKOPP ADLER 8967 설치 매뉴얼 - 페이지 8

{카테고리_이름} DURKOPP ADLER 8967에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 8967 14 페이지. Preface and general safety information
DURKOPP ADLER 8967에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

페이지 인쇄

4. Connecting the Sewing Drive to the Table Top

4.1 General

4.2 Drive Mounting

4.3 Voltage Compensation Motor/ Machine Head

Different drive and connections packages are available

for the machine.

The drive package consists of:

Motor, motor protection switch with wiring, belt, belt pul-

ley.

The connectios package contains all wiring between the

motor and the sewing head.

The direct current drive available for this machine is ope-

rated by a "monophase alternating voltage". Therefore,

with multiple machines, the connections must be uniform-

ly distributed to the individual phases of the mains supply

(3 phase). Otherwise, this could lead to an overload of

the individual phases.

Attention!

If the electronics are not supplied by Dürkopp Adler, then

manufacture and testing is to be conducted to EN 60204-

3-1/JEC 204-3-1.

–

Screw the drive with its base to the table top. Hereby

screw the 3 hex head M8 x 35 screws with washers

into the nuts in the table top.

–

Fasten the V-belt pulley to the motor shaft

–

Check the connections on the motor terminal board

and correct if necessary.

The arrangement must be appropriate to the mains

voltage.

–

Screw the green-yellow connecting cable found in

the enclosed package onto the motor base. It serves

to conduct the machine head static charge to ground

via the motor.