DURKOPP ADLER DAC basic 281 운영 매뉴얼 - 페이지 5
{카테고리_이름} DURKOPP ADLER DAC basic 281에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER DAC basic 281 18 페이지.
페이지 인쇄
1.1.2
Technician-level
The technician's level is unlocked by the following key combination:
When switching on the control unit and press the P button
time.
This allows access to the technician's level.
Press A+ to get into the technician's level.
L
C
P
Min
Backtack
t
00
00
300
t
00
01
0
00
02
0
t
t
00
03
0
t
00
04
0
t
00
05
0
t
00
06
0
t
00
10
300
t
00
11
0
t
00
12
0
t
00
13
0
t
00
20
300
t
00
21
0
t
00
22
0
t
00
23
0
t
00
30
0
t
00
31
0
t
00
32
0
© 2010 Dürkopp Adler AG
Max
Preset Unity
2500
1700
rpm
254
14
10°
254
10
10°
1
0
-
2
0
-
1
1
-
500
0
ms
2500
1700
rpm
254
10
10°
254
14
10°
1
0
-
4000
2800
rpm
254
22
10°
254
30
10°
1
0
-
1
0
-
2500
1200
rpm
1000
300
ms
and the reset button
Description
Start backtack speed
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the bartack)
Pre-control angle when turning th e backtack magnet off.
(Changing of backward forward at the bartack)
Start backtack with the position 0 of the pedal interruptible.
0 = off;
1 = on
Mode for the end of the start backtack.
0 = You sew further after the end;
1 = Machine stops and must be started by the pedal again;
2 = Thread performance after the start backtack
Pedal release only to an additional route A
0 = off;
1 = on
Delay time up to the speed release after the start backtack
End backtack speed
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the bartack)
Pre-control angle when turning the backtack magnet off.
(Changing of backward forward at the bartack)
Backtack magnet stays switched on (simple with the last
backward way final backtack and multiple backtack ends) till
the needle has been reached the Pos. 2.
0 = off;
1 = on
Start multiple backtack speed (only at the stuffing program)
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the backtack) (only at the
stuffing program)
Pre-control angle when turning the backtack magnet off.
(Change of backward forward at the backtack) (only at the
stuffing program)
Start backtack as a stuffing program.
0 = off;
1 = on
Ornamental backtack
0 = off;
1 = on
Ornamental backtack speed
Stop time at the ornamental backtack
II-5
Operating manual part II
at the same