Data Signs RF REMOTE 매뉴얼 - 페이지 6

{카테고리_이름} Data Signs RF REMOTE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Signs RF REMOTE 6 페이지.

Type-1 Operation

FLASHING YELLOW LIGHT.

You can set the Lights to Flash Yellow only.

This might serve as a caution or warning lights.

Note: The light(s) must be on RED to enable the Menu

item to switch on Flashing Yellow.

Self-Test

Note: Self test is only possible when lights are not operating (or prior to Startup)

When the

PTL Compact to test the aspects, on any connected units:

Green signal, yellow signal, red signal and blank for 0.2 seconds.

Note: the Red and Green Times are reset to the default times of

Green = 1 Second, Red = 1 Second.

It is advisable that the self-test not be carried out while the PTL's

are setup on the roadway.

Use the MENU button on the bottom of the screen to

open the SETTINGS menu screen.

From the menu screen, Startup or Shutdown the

connected PTL units.

The RF Channel as well as the STATUS is also

selected from this menu.

Press BACK to return to normal operating mode.

butto button is pressed, the following sequence is run on the

D ATA S I G N S A U S T R A L I A P T Y LT D

MAN 0011E Issue 2

Rev: 20/11/2023