DURKOPP ADLER 550-867 추가 지침 - 페이지 17

{카테고리_이름} DURKOPP ADLER 550-867에 대한 추가 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 550-867 20 페이지. Btsr sensor

Fitting the new parts

5.4 Installing thread lever protection

Abb. 20: Installing thread lever protection

1. Attach the thread lever protection (6) so that it is located as far down

2. Check the thread lever protection (6) does not collide with the thread

3. Tighten the screws (5) on the thread lever protection (6).

4. Loosen the screw (3) on the head cover (2).

5. Position the head cover (2) so it is flush with the machine again.

6. Insert the screw (1) on the head cover.

7. Tighten screws (1) and (3).

Abb. 21: Positioning the thread lever protection

Additional Instructions 550-867 - 01.0 - 08/2017

①

(1) - Screw

(2) - Head cover

(3) - Screw

from the sensor and as much to the right as possible from this and

thereby does not collide with the thread lever (4) .

lever (4).

⑥

⑤

④

③

②

(4) - Thread lever

(5) - Screws (concealed)

(6) - Thread lever protection