DURKOPP ADLER 767 - 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} DURKOPP ADLER 767 -에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 767 - 16 페이지. Converting bobbin hook clb 300
DURKOPP ADLER 767 -에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지), 사용 설명서 (16 페이지)

페이지 인쇄

2. Setting up

Packing must be removed prior to setting-up.

–

Remove safety bands and wood from upper part, table and frame.

–

Remove safety bands and block from motor.

2.1 Erecting the upper part

If the special sewing machine was not delivered fully assembled:

–

Screw hinges 2 and 3 to base plate.

Attach upper-part support 1.

–

Fit upper part.

–

Fit and tension V-belt (see section 2.3).

–

Fit belt guard and oil bath.

–

Align surge container 9.

The surge container must be turned so that it is vertical when the upper part of the

machine is vertical.

–

Place oil-recirculation felt 7 in the depression of the oil bath.

The hose 8 must not make contact with moving parts.

2.2 Transport

For internal transport the sewing machine must be lifted and moved by a suitable

vehicle (e.g. a fork-lift).

2.3 V-belt tension

After the machine has been moved the pre-set V-belt tension must be checked.

The tension in the V-belt 6 must be such that it can be depressed by about 10 mm by

applying finger pressure in the middle.

–

Loosen nuts 4 and 5.

–

Swivel drive until V-belt tension is correct.

–

Retighten nuts 4 and 5.

IMPORTANT !

The special sewing machine may only be set up by trained

specialist personnel.