DURKOPP ADLER 806 설치 지침 매뉴얼 - 페이지 18

{카테고리_이름} DURKOPP ADLER 806에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 806 19 페이지.

페이지 인쇄

Position balancing for the upper sewing position

–

The transfer carriage will move towards the lower sewing position.

–

By means of the function "Lifting/lowering the transfer plate "

lower the transfer plate.

–

Lower the sewing head by means of the function "Lifting/lowering

the sewing head".

–

It is possible to change the position of the transfer plate by the

arrow keys, but the position will not be memorised.

If the position is not correct, , loosen the 4 screws 1 on both sides

of the transfer lever and align the transfer plate so that the needle

dips into the lower bore hole.

NOTE !

After a new alignment of the transfer plate, it is necessary to

balance the positions.

–

Press the RETURN key.

The sewing head will be lifted.

The transfer plate will be lifted.

Position balancing for the beading station

–

The middle slide will advance.

The middle slide will be lowered.

The transfer carriage will move towards the beading station.

–

Lower the transfer plate by the function "Lifting/lowering the

transfer plate ".

–

By means of the arrow keys of the control unit align the transfer

plate so that the middle slide protrudes into the seam contour of

the transfer plate to the same extent at all sides..

The actual coordinates will be displayed.

–

Lift and lower again the transfer plate by the function

"Lifting/lowering the transfer plate ".

–

Check the adjusted position and correct it, if required.

–

Press the RETURN key.

The transfer plate will be lifted.

The middle slide will return.

Checking the positions

–

Press the key "F1".

The position balancing will be repeated.

–

Check the position adjustment of the transfer plate.

–

After checking the positions, press the key "F4".

This is the end of the position checking.