Data Technology 5150CRH 설치 매뉴얼 - 페이지 2

{카테고리_이름} Data Technology 5150CRH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Technology 5150CRH 6 페이지. Disk controller

*••
WARNING
no
This equipment generates and uses radio frequency
energy and if not installed and used properly, that is, in strict
accordance with the manufacturer's instructions, may cause
interference to radio and television reception.
It
has been
type tested and found to comply with the limits for a Class
B computing device in accordance with the specifications
in su bpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the in­
terference by one or more of the following measures:
Reorient the receiving antenna.
Relocate the computer with respect to the receiver.
Move the computer away from the receiver.
Plug the computer into a different outlet so that
computer and receiver are on different branch
circuits.
If necessary, the user should consult the dealer or
an experienced radio/television technician for
additional suggestions. The user may find the
following booklet prepared by the Federal Com­
munications Commission helpful:
"How to Identify and Resolve Radio- TV
Interference Problems".
This booklet is available from the U.s-.
Government Printing Office,
Washington, DC 20402.
Stock No. 004-000-00345-4
NOTE: When interfacing with an external device, a
shielded cable must be used to comply with FCC
regulations.
TABLE OF CONTENTS
1.0
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
2.0
Jumper Setup Instructions. . . . . . . . . . . . . . . . . . . 1
2.1
BIOS ROM Size Select Jumper . . . . . . .
.2
2.2
PROM Address and PROM Enable Jumper
.2
2.3
DM A Channel Selection Jumpers.
.2
2.4
Interrupt Selection Jumper
.3
2.5
Software-Readable Jumper
.3
2.6
Port Address Jumper.
.3
2.7
DC power connector .
·3
3.0
Cable Requirements . . . . . . . . . . . . . . . . . . . . . . 4
4.0
Initial Power Up. . . . . . . . . . . • . . . . . . . . . . . • . 4
5.0
Formatting The Disk . . . . . . . . . . . . . . . . . . . . . . 5
6.0
Drive type jumper settings. . . . . . . . . . . . . . . . . . . 7
Data Technology Corporation Part Number 09-00362B-l
Revision B October 12, 1987
This installation guide and the associated software and firmware
are copyright protected.
(C) 1987, Data Technology Corporation
IBM and PC/XT are trademarks of International Business Machines
Corporation.