Data Technology 5160X 설치 매뉴얼 - 페이지 2

{카테고리_이름} Data Technology 5160X에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Technology 5160X 4 페이지. Disk controller

페이지 인쇄

* * *

WARNING

* * *

This equipment generates and uses radio frequency

energy and if not installed and used properly, that

is, in strict accordance with the manufacturer's

instructions, may cause interference to radio and

television reception. It has been type tested and

found to comply with the limits for a Class B

computing device in accordance with the specifications

in subpart J of Part 15 of FCC Rules, which are

designed to provide reasonable protection against such

interference in a residential installation. However,

there is no guarantee that interference will not occur

in a particular installation.

this equipment does

cause interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient the receiving antenna.

Relocate the computer with respect to the

receiver.

Move the computer away from the receiver.

Plug the computer into a different outlet

so that computer and receiver are on

different branch circuits.

[f necessary, the user should consult the

dealer or an experienced

radio/~elevision

technician for additional suggestions.

The user may find the following booklet prepared by

the Federal Communications Commission helpful:

"How to Identify and Resolve Radio-TV

Interference Problems"

This booklet is available from:

u.s.

Government Printing Office

Washington, DC 20402.

Stock No. 004·000-00345-4

NOTE: When interfacing with an external device, a

shielded cable must be used to comply with FCC

regulations.

1.0 Introduction

This easy to install RLL hard disk controller is able to

control a maximum of two ST-506 type industry standard

3-1/2" or 5-1/4" Winchester RLL disk drives under IBM PC

DOS version 2.0 or later on an IBM PC/XT or

compatible.

PLEASE READ THIS INSTALLATION GUIDE CAREFULLY

BEFORE STARTING INSTALLATION

, 6

,C::::J

' "

ill

BIOS

FIGURE 1. JUMPER AND CONNECTOR LOCATIONS ON

DTC-5160X

2.0 Jumper Option Setup Instructions

The following information pertains to the DTC-5160X

when used with Data Technology Corporation's CRD BIOS.

2.1

BIOS Address Jumpers

The B[OS address jumpers (W2 pins 3-4 and 5-6)

allow the BIOS address to be relocated. The

default setting places it at address C800:0000.

As shown below, alternate addresses can be

selected by changing the jumpers.

- 1