DUROFIX RI60165 정보 매뉴얼 - 페이지 13
{카테고리_이름} DUROFIX RI60165에 대한 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DUROFIX RI60165 16 페이지. Brushless impact wrench
페이지 인쇄
1.
Align the holes of metal hook to the tool housing.
2.
Use screws to fasten the metal hook to the tool housing.
NOTE
Always check the direction of the rotation before use.
ETC MODE SETTING & DISPLAY
Press the right icon
on the bolts of nuts. (selected one will be lightened on).
There are two ETC modes on, it will be auto shut off on setting of the low and middle
torque. The high torque setting will not be shut off automatically.
Remark : If the red LED bright, it means there is the error or start up protection.
BATTERY POWER INDICATOR
Trigger the tool and Battery Indicator to show the battery pack's remaining capacity
1.
One light ON: 30% remaining capacity.
2.
Two lights ON: 60% remaining capacity.
3.
All lights ON: 100% remaining capacity.
1.
After continuous use, allow the impact wrench to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
2.
Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
Align Hook to Hole
OPERATION
C
D
E
to select the tightening torque which you would like to apply
-13
Fasten with Screw
A
B