4gon RouterBOARD 411 빠른 설정 매뉴얼 및 보증 정보

{카테고리_이름} 4gon RouterBOARD 411에 대한 빠른 설정 매뉴얼 및 보증 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. 4gon RouterBOARD 411 2 페이지.

RouterBOARD 411

Quick Setup Guide and Warranty Information

Assembling the Hardware

First use of the board:

●

Insert the MiniPCI card. RouterBOARD 411 provides one

MiniPCI slot on the top of the board

●

Connect antenna cables to the MiniPCI card

●

Install the board in a case and connect other peripherals

and cables.

●

Plug in power cable to turn on the board.

Powering

The board accepts powering from either the power jack or the

LAN1 Ethernet port:

●

direct-input power jack J7 (5.5mm outside and 2mm

inside diameter, female, pin positive plug) accepts

9..28V DC (overvoltage protection starts at 28V).

●

LAN1 Ethernet port J8 accepts 9..28V DC input (at the

board; higher voltage needed to compensate for power

loss on long cables; at least 18V suggested) from

non-standard (passive) Power over Ethernet injectors

(no power over datalines). The board does not work

with IEEE802.3af compliant 48V power injectors.

The maximum output of the power supply available for extension cards is normally 10W (3.0A).

Booting process

First, RouterBOOT is started. It displays some useful information on the onboard RS232C asynchronous serial port. The serial

port is set by default to 115200bit/s, 8 data bits, 1 stop bit, no parity. Note that the device does not fully implement the

hardware (RTS/CTS) flow control, so it is suggested to try to disable hardware flow control in the terminal emulation

program in case the serial console does not work as expected, and if it does not help, make a new cable using the pinout

given in the User's manual. The loader may be configured to boot the system from the onboard NAND, and/or from network.

See the respective section of User's manual on how to configure booting sequence and other BIOS parameters.

DHCP or BOOTP (configurable in loader) protocols allow the RouterBOARD 411 series board to get an initial IP address, and

provide the address of a TFTP server to download an ELF boot image from. It is especially useful for software installation.

See the User's manual for more information and protocol details. Note that you must connect the RouterBOARD you want to

boot and the BOOTP/DHCP and TFTP servers to the same broadcast domain (i.e., there must not be any routers between

them – they must be on the same Ethernet switch).

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

rev. A (28-Jan-2008)