Data-Tronix DT-CAT648P 설치 매뉴얼 - 페이지 3

{카테고리_이름} Data-Tronix DT-CAT648P에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data-Tronix DT-CAT648P 4 페이지. 24 port and 48 port category 6 cable patch panel

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.

Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is

clean, and no connectors are broken, damaged, or loose.

damaged or defective please contact your distributor or Datatronix at 1-610-429-1511 for

assistance.

3. INSTALLATION and CONNECTIONS

a. AWG 22-24 Category 6 cable wires are recommended for this unit.

b. This patch panel supports T568A and T568B wiring configurations. Verify the wiring

configuration conforms to the wiring color scheme depicted on the back panel cover.

c. Use the proper termination tools such as a 110 Impact Tool

or Krone Impact Tool.

d. Using the supplied screws the patch panel should be

installed

communications cabinet.

e. Remove 3" of jacket insulation and center spline from the cable. Leave no more than

8mm or 0.3 inch of wire to make the connection to the IDC slots.

Locate the jacketed cable above the IDCs.

g. Using the wiring color scheme displayed on the back panel,

terminate each cable pair in its color slot. Ensure the solid

colored wire of each pair is placed in the correct slot. Use a

110 or Krone Impact Tool to impact the wire into the 110IDC.

h. Place the IDC cover over the connections to reduce the

presence of dirt and moisture on the connections in

addition to better securing the wires.

v1.0 11/11/11

INSTALLATION

any

standard

19"

If equipment appears to be

equipment

rack