Cavalry CADA001U32A 사용자 설명서 - 페이지 14

{카테고리_이름} Cavalry CADA001U32A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cavalry CADA001U32A 15 페이지. Raid enclosure
Cavalry CADA001U32A에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

Decide which RAID setting

you want, and, following

the diagram to the right,

move the jumper shunts to

cover the appropriate pins.

(On the diagram to the

right, grey indicates that a

pin is covered; white

indicates an uncovered pin.)

The jumper shunts may be

moved by gently pulling

them upwards (vertically)

until they are free, then

pushing them downwards

onto the appropriate two

pins.

NOTE: If switching from any mode to RAID 1 mode, you must first configure

the jumper block to "Single" mode. Then connect your drive to your

computer, turn on your drive, and repeat step 5 (un-initialization) on BOTH

drives (in single mode, the array will show up as two drives). Then you may

continue again from Step 6 and configure the jumper block to RAID 1.

NOTE: When placing the jumper shunts, make sure they are oriented

along the longest axis of the drive. For example, if you want RAID 1

mode, one jumper shunt would cover pins 1 and 2, and another jumper shunt

would cover pins 4 and 5, as opposed to one jumper shunt covering pins 1

and 4, and another jumper shunt covering pins 2 and 5.

Fig. A (below) shows how the [uncovered] jumper pins are numbered. The

black arrow points to the back of the drive.

Fig. A