4iiii Sportiiiis 사용자 설명서 - 페이지 18

{카테고리_이름} 4iiii Sportiiiis에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4iiii Sportiiiis 19 페이지. Heads up display system
4iiii Sportiiiis에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지), 사용자 설명서 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

7
Pairing ANT+ Sensors with Sportiiiis
 Pairing ANT+ Sensors
For best results perform pairing at least 30 feet away from any active ANT+ devices that
you would not like to pair with your Sportiiiis unit.
1) Make sure that all ANT+ sensors that you would like to pair with are active* and
within range (< 6ft)
2) With Sportiiiis off, hold down the button until you hear Sportiiiis say "Pairing"
3) Release the button - Sportiiiis will say "Start Pairing"
4) Sportiiiis will enunciate all sensors that it finds and pairs with
*To activate a HR strap, put on the strap. For a bike speed/cadence sensor, spin your
wheel to activate your sensor. For a footpod, shake the footpod, or move your running
shoes if attached.
 Unpairing ANT+ Sensors
Within the Sensors tab of the Sportiiiis Configuration Utility, you may remove paired
sensors from Sportiiiis individually (for more info see page 10)
 Switching between Run and Bike mode
You can switch the zone profiles on-the-fly between Bike and Run as setup in the
Configuration Utility.
1) To tell which profile your unit is currently in, turn your unit on and it will list your
profile as well as your current battery power.
2) Hold down the multifunction button until the Sportiiiis announces "Mode". When it
announces "Mode" it will change your unit from its current profile.
Page 18
Sportiiiis
User Manual
Version 1.04