4iiii Sportiiiis 사용자 설명서 - 페이지 2
{카테고리_이름} 4iiii Sportiiiis에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4iiii Sportiiiis 2 페이지. Heads up display system
4iiii Sportiiiis에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄Getting to Know Your Sportiiiis Unit
Speaker
Micro-USB Port
gives audio prompts
connect to computer
either when triggered
to configure, charge,
by TipTap or (option-
and sync your Sportiiiis
ally) when above or be-
unit
low zone for currently
enabled sensor
Welcome to Sportiiiis!
Thank you for purchasing Sportiiiis. Sportiiiis is a heads-up display – it gives you the feedback you
need while running or cycling to stay in your target range (zone) for heart rate, cadence, power, and
pace/speed, without having to look down at a watch, cyclocomputer, etc. It can pair with, and receive
data from any ANT+-enabled heart rate strap, foot pod, power, or speed/cadence sensor.
When properly mounted to your glasses, the boom of the Sportiiiis unit will be in your peripheral vi-
sion, so that its LEDs can tell you whether you are below, above, or in your zone by their color (green,
yellow, orange, or red) and position.
Through the downloadable Windows, Mac or Smartphone Configuration Utility, you can set up the
Sportiiiis unit and configure the zones for your individual needs.
What's in the Box?
USB Charge/Sync Cable
Power Button
Boom
capacitive-touch but-
contains
seven
ton (merely has to
(Light-Emitting Diodes)
be touched, cannot
that can be programmed
be depressed), pow-
by color and position to
ers Sportiiiis on and
indicate where your per-
off and controls other
formance is relative to
functions
the target zone for your
currently-enabled sensor
Sportiiiis Unit
(2) Mounting Brackets
(10) Tie Wraps
Functions of the Power Button
ACTION
SPORTIIIIS POWERED ON
press Power Button
(unit beeps once)
hold Power Button until
unit beeps twice
hold Power Button until
unit beeps three times
hold Power Button until
unit beeps four times
Your Sportiiiis unit contains an accelerometer, which allows it to respond to single and double "taps. "
LEDs
While it is powered on, a single tap will cause your Sportiiiis unit to enunciate the measurement from the
active sensor, and a double tap (two taps in succession) will switch between currently paired sensors.
QUICK START GUIDE
SPORTIIIIS POWERED OFF
start/stop session
show remaining battery power
turns Sportiiiis unit off
turns Sportiiiis unit on
switch bike/run mode
--------------
clear all paired sensors & pair
TipTap
pair sensors