Duronic EPS 매뉴얼 - 페이지 5

{카테고리_이름} Duronic EPS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duronic EPS 18 페이지. Electric projector screen

페이지 인쇄

Troubleshooting

Occasionally, you may notice that the screen does not extend to the correct

length or completely retract. You can easily adjust the limited device to solve

these problems.

"A" controls the range of extension

"B" controls the range of retraction

- If there is a wife black border across the top of the screen, turn "A" clockwise.

- If there is a narrow border across the top of the screen or the screen stops

extending mid-way, turn "A" anti-clockwise.

- If the bottom black border appears wide when the screen stops or the screen

does not fully retract, turn "B" anti-clockwise.

- If the screen does not stop moving, even after is has been fully retracted,

turn "B" clockwise.

If any other problems occur that are not noted here, please do not operate

your projector screen.

Contact [email protected] for any enquiries.

Red Hex Screw - A

White Hex Screw - B

Warranty

1 Year Guarantee from Shine-Mart Ltd, Trademark owners of Duronic Products.

NOTE: THESE STATEMENTS DO NOT AFFECT YOUR STATUTORY RIGHTS AS A

CONSUMER

This product has been manufactured under the strictest or quality control procedures, and

using the highest quality of materials, to ensure excellent performance and reliability. It will

give very good and long lasting service, provided it is properly used and maintained. The

product is guaranteed for 1 years from the date of original purchase. If any defect arises due

to a faulty materials or poor workmanship, the faulty product must be returned to the original

place of purchase. Refund or replacement is at the discretion of that company.

Duronic Products are offered with a 1 year guarantee under the following conditions:

1. The product must be returned to the retailer with original proof of purchase.

2. The product must be installed and used in accordance with the instructions contained in

this operating manual.

3. It must be used only for domestic purposes.

4. It does not cover wear and tear, malicious damage, misuse, neglect, inexpert repairs or

consumable parts.

5. Shine-Mart Ltd has no responsibilities for accidental or consequential loss or damage.

6. Shine-Mart Ltd are not liable to carry out any type of servicing work, under the guarantee

7. Valid in the UK only

This product is fitted with BS:1363 plug and fuse

Imported by Shine-Mart Ltd, RM3 8SB

Information on waste Disposal for Consumers of

Electrical & Electronic Equipment.

This mark on a product and/or accompanying documents indicates that when it

is to be disposed of, it must be treated as Waste

Electrical & Electronic Equipment, (WEEE).

Any WEEE marked products must not be mixed with general household waste,

but kept separate for the treatment, recovery and recycling of the materials used.

For proper treatment, recovery and recycling; please take all WEEE marked

waste to your Local Authority Civic waste site,

where it will be accepted free of charge.

If customers dispose of Waste Electrical & Electronic Equipment correctly, they

will be helping to save valuable resources and preventing any potential negative

effects upon human health and the environment, of any hazardous materials that

the waste may contain.