Cavalry EN-CAHDD2BU3C-ZB 사용 설명서 - 페이지 5

{카테고리_이름} Cavalry EN-CAHDD2BU3C-ZB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cavalry EN-CAHDD2BU3C-ZB 9 페이지. Usb 3.0 duplicator dock

INSTALLATION GUIDE

Setup Your Dock

JBOD (Standard) Installation Guide

Disk Duplicator Installation Guide

Initializing and Formatting Your Disks

INSTALLATION STEPS

STEP 1: SET UP YOUR DOCK

Connect the Cavalry power supply.*

Connect the USB cable to a port on your computer that you

have used recently and know to work well. Take this time to

temporarily eject and disconnect any other external storage

devices you have. This will make it easier to find your new

Cavalry dock.

(For both MAC and PC)

Insert the hard drives that you are going to

use into the dock.** Make sure that you handle

them very carefully. Check that they are firmly

inserted into the dock.*** Be sure that you never touch any exposed circuitry or data ports

on the drive or the dock. Hard drives are very fragile devices!

Proceed to the Installation Guides below depending on the RAID-Mode of your choice.

*note: Take a moment to label your power supply with the Cavalry Model # of your unit. A piece of light-colored masking tape

or an address label works great, and can save you tons of time and frustration down the road. Just make sure it is attached well.

**note: Depending on the drives used when powering on, allow up to 30 seconds for both drives to spin up to speed.

***note: Ensure a proper connection when inserting a drive by putting it straight down and not tilting it. If a drive is not being

detected, turn off the dock then remove and re-insert the drive.

Caution: Removing the hard drives from the dock while it is on may result in data loss.

EN-CAHDD2BU3C-ZB

CHAPTER