4IPNET EAP220 사용자 설명서 - 페이지 19

{카테고리_이름} 4IPNET EAP220에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4IPNET EAP220 20 페이지. Enterprise access point
4IPNET EAP220에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (18 페이지)

페이지 인쇄

Step 2. Connect one end of the Ethernet cable to the Uplink port and the other end of the cable to a switch, a

router, or a hub. The EAP747 / EAP750 / EAP757 is now connected to your existing wired LAN

network.

Step 3. There are two ways to supply power to EAP747 / EAP750 / EAP757

a) Connect the DC power adaptor to the power jack socket.

b) The Uplink port is capable of receiving PoE. Connect an IEEE 802.3af/at-compliant PSE device

(e.g. a PoE-switch) to the Uplink port of EAP747 / EAP750 / EAP757 with the Ethernet cable.

Please follow the steps mentioned below to install the hardware of OWL530 / OWL610 / OWL620:

Step 1. Connect an antenna to the Access Point's antenna connector.

Step 2. Connect the Ethernet Port of OWL530 / OWL610 / OWL620 to the POWER & DATA OUT Port of a

802.3af PSE device.

Step 3. Connect one end of an Ethernet cable to the Data In Port of PSE and the other end to the computer.

Step 4. Power on the PSE in order to supply adequate power to the OWL530 / OWL610 / OWL620.

Now, the Hardware Installation is complete.



Please use only the power adapter supplied with the package. Using a different power

adapter may damage this system.



To verify the wired connection between the AP and your switch / router / hub, please also

check the LED status indicator of the respective network devices.

Enterprise Access Point ENGLISH

User's Manual