Cavecool Affection Onyx CC168SB 사용자 설명서 - 페이지 3

{카테고리_이름} Cavecool Affection Onyx CC168SB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cavecool Affection Onyx CC168SB 16 페이지.
Cavecool Affection Onyx CC168SB에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

페이지 인쇄

Before using your wine cooler

Remove the exterior and interior packaging.

• Before connecting the wine cooler to power source, let it stand upright for approximately 2

hours. This will reduce risk of a malfunction in the cooling system from handling during

transportation.

• Clean interior surface with lukewarm water by using a soft cloth.

• When replacing the illuminating lamp, please select the lamp which comply with rated

power input of lamp according to the rating label. Shut off the power supply before replacing

the lamp.

• When disposing your appliance, please choose an authorized disposal site.

Installation of your wine cooler

• Place your wine cooler on a floor/surface that is strong enough to support it when it is fully

loaded. To level your wine cooler, adjust the levelling leg at the bottom of wine cooler.

• Locate the wine cooler away from direct sunlight and sources of heat (stove, heater,

radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase

energy consumption. Extreme cold ambient temperatures may also cause the unit not to

perform properly.

• Avoid locating the unit in moist areas.

• Plug the wine cooler into an exclusive, properly installed wall outlet. Any questions

concerning power should be directed toward a certified electrician or an authorized products

service center.

Attention

Store wine in sealed bottles. Do not overload the cabinet. Do not open door unless

necessary. Do not cover shelves with aluminium foil or any other shelf material which may

prevent air circulation. Should the wine cooler be stored unused for a longer period of time, it

is suggested, after a careful cleaning, to leave the door ajar to allow air to circulate inside the

cabinet in order to avoid possible formation of condensation, mold or odours. The carbon

filter should be cleaned and dried at least once a year.

- 3 -