Durr Dental VISTACAM2 설치 및 운영 지침 매뉴얼 - 페이지 5
{카테고리_이름} Durr Dental VISTACAM2에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Durr Dental VISTACAM2 13 페이지.
페이지 인쇄• This product is a medical-technical
appliance and may only be operated or
used by someone who has been trained or
who has experience of how to use the
appliance correctly.
• Before every use the operator must check
the functional safety and the condition of
the appliance.
• The operator must be knowledgeable in the
operation of the appliance.
• The product is not designed to be used in
medical treatment areas where there exists
the danger of explosion. Areas where
explosions could occur are those where
flammable anesthetic material, skin
cleansers, oxygen and skin disinfectants
are present. This appliance is not to be
used in all areas where the atmosphere
could cause fire.
1.4 Using Peripheral Devices
Only peripheral devices (computer,
monitor, printer) may be connected to
this appliance which conform to
standard IEC 950 (EN60950).
The PC-unit must be located away
from the patient treatment area (1.5m
from the patient).Ensure that the PC
system cannot be touched by either
patient or operator during use. Where
this is not possible, then the PC-unit
employed must be installed subject to
safety standard EN60601-1.
• Units may only be connected to the system
or to other units when it has been
established that there is no reduction of
safety for the patient, the operator or the
environment through such connection.
Where it is not absolutely clear from the
documentation whether the safety is
reduced by such connection, then the
operator must establish, e.g. by contacting
either the manufacturer or an expert, that
there is no reduction of safety for the
patient, the operator or the environment
through such connection.
1.5 Electrical Safety Notes
• The Dürr VistaCam2 Docking Station may
only be connected to an earthed safety
socket.
• Before connecting the appliance to the
power supply check that the electrical
current and the frequency of the device as
described on the appliance are compatible
with that of the power supply.
• Check the appliance and the power supply
cables for possible damage before
switching on. Damaged cables, plugs and
sockets must be replaced before use.
• Never touch open supply outlets and
patients simultaneously.
1.6 Warnings and Symbols
In the Installation and Operating Instructions
use is made of the following terms or symbols
to denote information of special importance:
Information and/or mandatory
regulations or prohibitions for the
prevention of personal injury or
substantial property damage.
Special information regarding the
economical use of the equipment and
other information.
CE-Labeling without Notified Body
Nummer.
Observe Installation and Operating
Instructions.
Fuse: 2 pieces T 1.0 AH
Connection for potential equalization
17