ELRO LP152012 매뉴얼

{카테고리_이름} ELRO LP152012에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ELRO LP152012 2 페이지. Motion sensor

페이지 인쇄
ELRO LP152012 매뉴얼
LP152011/LP152012
MOTION SENSOR
Your security motion sensor is a fully automatic indoor
and outdoor security/courtesy light controller capable
of controlling up to 1000W incandescent, 400W
fluorescent or 150 Watt. Time and LUX adjustment
functions let you select how long and when the light
will stay on after activation.
Note: Read this entire manual before you start to
install the system.
SAFETY INSTRUCTIONS
Do not attempt installation unless you have some
experience with household wiring.
Before proceeding with the installation;
TURN OFF THE POWER TO THE LIGHTING
CIRCUIT AT THE CIRCUIT BREAKER OR FUSE
BOX TO AVOID ELECTRICAL SHOCK
DO ensure that the power supply circuit is protected
by a 16 amp circuit breaker or suitable equivalent
fuse..
DO NOT install this motion sensor when it is raining.
Wall mounting, 1.8~2.0m above the ground.
Ceiling mounting, 2.5~4.0m above the ground ed.
Outdoor installation; under eaves is preferable.
Do not allow sunlight to fall directly on the front of
unit, and try to avoid pointing the unit at trees or
shrubs or where the motion of pets may be
detected.
SENSOR
LESS SENSITIVE
SENSOR
MORE SENSITIVE
200 degree
Install a wall switch adjacent to the power source. This
helps you operate AUTOMATIC OPERATION and
MANUAL OVERRIDE with ease.
Make use of the base cover as a template to mark the
position of two screw holes on the wall or on the
ceiling.
Strip approximately 6-8mm insulating part of the wires
from the power cord. Before connection, run the wires
through the rubber seal provided.
For wire connection:
1