Addvent AVAC9000CM 설치 지침 및 사용자 설명서 - 페이지 4

{카테고리_이름} Addvent AVAC9000CM에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addvent AVAC9000CM 4 페이지. With 12 hour timer

페이지 인쇄

AVAC9000CM[07]instructions

29/1/07

Installation

Exhaust Duct Set Assembly and Installation

Connect exhaust hose assembly to the back of the unit.

Extend hose to desired length and locate the exhaust

nozzle through the window for ventilation.

Insert both ends of the exhaust hose into the two

exhaust nozzle connectors by twisting anti-

clockwise until they stop.

Fix one of the connectors to the rear outlet of

the unit. This is achieved by sliding the nozzle

connector downwards over the exhaust outlet of

the unit ensuring that the lugs on the nozzle

connector are engaged with the grooves on the

connector of unit.

Fix the other exhaust nozzle connector to the

exhaust nozzle.

Extend the exhaust hose and close the window as

much as possible trapping the exhaust nozzle.

Semi-permanent Installation

If required, your appliance can also be installed

semi-permanently.

Drill a 125mm hole in an outside wall* or through a

window pane.

The unit should not be within 300mm of any wall.

Fit the flange accessory fixture provided in the hole.

Fit the exhaust hose in the housing at the back of the appliance.

Insert the other end of the exhaust hose to the flange previously fit on

the wall as shown in Fig.3.

When the hose is not in use, place the cap for connector to cover the

hole.

NOTE : When installing the air conditioner semi permanently, you should

leave a door slightly open (as little as 1cm) to guarantee sufficient

ventilation.

* Installing through an outside wall: you are recommended to insulate the

section of wall using suitable insulation material.

14:37

Page 6

Exhaust nozzle

Exhaust

hose

Exhaust nozzle

connectors (2)

Troubleshooting

The following cases may not always be a malfunction, please check

it before asking for service.

Problem

Analysis

Does not operate

If the protector tripped or fuse is blown.

Please wait for 3 minutes and start again,

protector device may be preventing unit to work.

If the plug is not properly plugged.

Stop during operation

If the set temperature is close to room

temperature, you can adjust the temperature.

Air outlet or intake be blocked.

Take the obstacle away.

Operating but not

If the door or window opened.

cooling

If there is other heater appliance working,

like heater or lamp, etc.

The air filter is dirty, please clean it.

Set temperature is too high.

Air outlet be blocked by obstacle.

Does not operate and

Drain the water into a prepared container by

water full indicator is lit the drainage pipe on the rear panel of the

unit. If still doesn't work, please consult a

qualified technician.

Maintenance

Maintenance after using

If unit is quite dirty use a mild detergent and damp cloth.

If the appliance will not be used for a long time, be sure to pull out the rubber

drainplug to allow the water to drain.

Before storing away run the unit in fan mode only for few hours to dry any

moisture on the coils to prevent mould.

Clean the air filter and reinstall it.

Remove the air hoses and store; cover the wall vent with the supplied cap.