Addvent AVACSPL12N 설치 지침 및 사용자 설명서 - 페이지 12
{카테고리_이름} Addvent AVACSPL12N에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addvent AVACSPL12N 17 페이지. Split air conditioners
AVACSPL12+18Ninstructions
Operation
Auto Operation
To select the Auto Operation Function press the MODE button.
A slight touch can initiate Auto Operation, effectively turns the room
ambient to its most comfortable condition.
Start operation
G
Press I/O button,
When AUTO operation is displayed, the air conditioner will set the room
temperature to the most comfortable condition.
Stop operation
G
Press I/O button
G
To decrease temperature, press button
Every time you press this button, it reduces the temperature 1°C.
G
To increase temperature, press button
Every time you press this button, it raises the temperature 1°C.
G
When auto operation is not displayed, press MODE or
auto operation mode.
Every time the button is pressed. operation mode changes in sequence of
AUTO COOL DRY HEAT or FAN (for Indoor display cooling only
unit).
Operating modes
When started, operation mode will turn into cooling or dehumidifying or
heating as per room temperature. lf operation stops for two hours, it restarts
in the same set mode as before operation was stopped even if room
temperature has changed. lf you do not like the start-up mode, press MODE
to reselect an alternative mode.
NOTE: When the desired temperature in the room is above or below the set
temperature by 2°C, set either COOL or HEAT function to change the
temperature to the desired level. This change may take a short time to take
effect.
Select Operation Mode (cooling,
dehumidifying, heating)
Select operation to finely adjust temperature or air direction.
To select cooling, dehumidifying and heating.
G
Press I/O button
G
Press MODE to select operation mode.
Every time the button is pressed. operation mode changes in sequence of
AUTO COOL DRY HEAT .
For cooling only unit, operation mode changes in sequence of
AUTO COOL DRY HEAT .
G
Press I/O button
To change temperature
Press M TOO HOT button to reduce temperature.
G
Every time you press it reduces 1°C.
Press L TOO COLD button to increase temperature
G
Every time you press it increases 1°C.
12/3/08
09:06
Page 12
see figure 15
TOO HOT
TOO COLD
see figure 17
Figure 15
Figure 16
to set it to
ROOM TEMP
AT START UP
Above 25°C
21–25°C
Below 21°C
Figure 17
12
OPERATION
TARGET TEMP
MODE
PRIMARY CONDITION
Cooling
About 24°C
Dehumidifying
–
Heating
About 24°C