DataComm Electronics 45-8017-1 지침/설치 시트
{카테고리_이름} DataComm Electronics 45-8017-1에 대한 지침/설치 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. DataComm Electronics 45-8017-1 2 페이지. Connected media box
페이지 인쇄Instruction / Installation Sheet
Connected Media Box
Part # 45-8017-1, 45-8011-1P, 45-8021-1S & 45-8031-1C
Parts Included:
● Connected Media Box Enclosure
● Trim Ring
● Two (2) Power Supply Mounting Brackets
● Two (2) 20" Hook and Loop Fasteners
Feature Identification:
A) Knock-outs for standard sized conduit
B) Retrofit mounting holes for old work installation
C) Industry Standard mounting holes for phone and video modules
made by DataComm Electronics and other major manufacturers
D) Knock-out for metal outlet or J-Box (must have UL and/or ETL
approval)
E) Mounting Brackets to hold One Connect Box or other TV power
sources
F) Two (2) large knockouts for access to USB ports
Installation Instructions:
1. Location Selection
The Connected Media Box will fill an entire stud bay horizontally. Make sure the box will fit either below the TV mount or to the side and still be able to
be covered by the TV. The outside dimensions of the trim ring are 17.50" W x 18" H.
Locate the panel in close proximity to a 110VAC for power requirements of amplifier or security panels. There is an outlet knockout in the bottom of the
panel for the installation of an UL and/or ETL approved
outlet or J-Box.
NOTE: Have a licensed electrician install the outlet to meet current code requirements.
NOTE: There is no fire rating on this panel, therefore, it should not be installed in fire rated walls.
Tools Needed:
● Flat Blade and Phillips Head Screwdriver
● Drill is optional
● Utility Knife
● Four (4) Metal Wood Screws
C
B
F
Page 1 of 2
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.DataCommElectronics.com
E
A
REVISED 02/20/2020
D