Durst X2500MS 사용 설명서 - 페이지 3

{카테고리_이름} Durst X2500MS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Durst X2500MS 7 페이지.

페이지 인쇄

PG 4

SUPER

CAPACITOR

STATUS

WARNING:

Do not switch to START

unless the READY light is on

CHARGER

STATUS

READY - The green light indicates your Hypastart is ready

for operation. The green light will turn on when the

supercapacitor voltage reaches 13.5V being 50% capacity

level. The Hypastart will continue to charge to a maximum

of 15.0V.

ENERGIZE - Indicates that the charge/energize

process is active.

SUPERCAPACITOR STATUS - This LCD display shows the

supercapacitor active voltage and capacity level indicated

in a 0-100 percentage form. Supercapacitor voltage and

capacity ranges from 12V to 15V, with 12V being 0% and 15V

being 100% with a maximum of 15.0V.

PLEASE NOTE THAT THE HYPASTART DOES

NOT NEED TO BE AT 100% CAPACITY LEVEL

TO OPERATE

OPERATING

INSTRUCTIONS

OFF

ENERGIZE

12 VOLT

24 VOLT

START

OFF - Your Hypastart should always be in the off position

when not in use.

ENERGIZE - Your Hypastart has two Energize switches

and is used to energize the unit prior to starting the engine.

Depending on the engine size you are starting, you can

either select 12V or 24V start.

12V START - This is the 12V starting position and only be

to used on a negatively grounded vehicle.

ONLY SWITCH TO THE 12V START WHEN

THE GREEN LIGHT IS ON

24V START - This is the 24V starting position and only to be

used on a negatively grounded vehicle

ONLY SWITCH TO THE 24V START WHEN

THE GREEN LIGHT IS ON

OPERATING

INSTRUCTIONS

PG 5