Elsat iNode Control ID 사용 설명서 - 페이지 8
{카테고리_이름} Elsat iNode Control ID에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsat iNode Control ID 11 페이지.
페이지 인쇄iNode Control ID – instruction manual
3. Battery replacement
The CR2032 battery from iNode Control ID should work up to 12 months. So really the speed of
consumption depends on many factors such as operating temperature, frequency of collaboration
with the PC or Smartphone (reading the recorded data), set the transmit power level, etc.
Characteristics of the battery voltage as a function of time is over a long period of time, practically
flat. Only at the end of the battery voltage begins to decrease sharply, and its internal resistance,
which leads to rapid consumption.
In order to replace the battery:
Open the cover:
1.
The iNode cover can be opened without the use of tools. The most comfortable way
to do it like the walnut shell opens. Simply insert into the gap between the two parts
of the casing nails of thumbs and opens it. Inside there is a printed circuit board, with
the metal battery holder.
Remove the circuit board from the enclosure:
2.
The battery is inserted into the holder on the side. It can not be removed if the plate
is located in the housing.
Pull out the holder the old battery.
3.
Insert the new battery:
4.
The battery like a coin has two sides. On one of them there is a large "+" sign and
usually the name of the manufacturer. The other party usually has no markings. Insert
the battery so that the side marked "+" touches with metal handle (it has also the "+"
sign). If the operation was carried out correctly the LED should start flashing.
Insert the circuit board into the housing:
5.
The printed circuit board is not perfectly round has a slight chamfer on one side.
Suits him a little bulge inside the case. By inserting the plate into the housing, pay
attention to these two items were facing each other.
Close the cover:
6.
On one of the parts of the enclosure there is a pin. You need to set it up so that it was
in the vicinity of the beheading described in the previous paragraph. Only with this
setting the cover will close properly
ELSAT s.c.
page 8