Cavotec MC-3000 운영 및 유지보수 매뉴얼 - 페이지 9
{카테고리_이름} Cavotec MC-3000에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cavotec MC-3000 9 페이지. Industrial remote control
페이지 인쇄
Micro-control as
Table 2: Possible indications in the Base Unit display
If the system has a 4 digit LED module the indicated codes are displayed there. If the system has a
LCD module the error codes are displayed in a field in the display.
Display Description
"XXX"
System ID code.
Is normally displayed a short moment when the
terminal is "turned on". Is displayed in systems
with only one terminal.
"XXX.Y" System ID code and terminal number.
Is normally displayed a short moment when the
terminal is "turned on". Is displayed only in
systems with more than one terminal.
"X.YY"
The battery voltage measured in volts.
(The number displayed has two decimals, the
values will be between 6.40 and 9.00.)
Is normally displayed a short moment when the
terminal is "turned on".
"A-XX"
Analog channel that can be programmed. (The
number displayed is an integer between 1 and
13.)
Is displayed only when the terminal is in
programming mode.
" A-00"
No analog channel is activated.
Is only displayed when the terminal is in
programming mode.
E001
Processor fault.
Indicates a processor module fault and/or a
processor fault.
E002
Activity at start-up.
A joystick is out of center position, or a switch is
in ON-position.
E003
Radio fault.
E004
Shutdown because of low battery voltage.
E005
Keyboard fault.
The terminal is not able to "read" switches,
joysticks etc.
E006
Shutdown because of inactivity.
The terminal will soon "turn itself off" since no
switches, joysticks etc. has been activated.
E007
Priority stop.
The stop button or the chock detector has been
activated.
MAN-05-006
Operation and Maintenance Manual for MC-3-series
Action
None
None
None
None
Activate the analog channel that you wish
to program!
Ensure that the processor module
BOOT-jumper is not turned on!
Replace the processor module and/or the
processor!
Set all switches/joysticks to OFF-position
and/or neutral position!
Change the Radio module.
Replace the battery!
There is a fault at the MC-ITX input
module.
Activate a function.
Turn the terminal OFF and ON again to
start normal operation!
Page 9 of 9
Rev. 1