Elsema AXIOM iS600 Series 사용자 설명서 - 페이지 9

{카테고리_이름} Elsema AXIOM iS600 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsema AXIOM iS600 Series 16 페이지. Sliding gate opener

E. GEAR RACK INSTALLATION

1. Move the Gate leaf to fully closed position.

2. Place the first piece of the rack over the pinion leaving about 1.5mm gap and mark the

drilling point on the gate, drill a pilot hole and screw the rack using the self-tapping screw

with the reinforcing plate.

3. Move the gate manually, making sure that the rack is resting on the pinion and fix all

other screws.

4. Bring the next rack and join it to the previous one by slotting it into inter-connecting slots.

5. Repeat this process until the gate is fully covered from fully open to fully close positions.

F. CHECK GEAR RACK INSTALLATION

 Make sure that the rack is constantly in full contact with the pinion for the full open and

close travel cycle.

 Manually check if the gate reaches the mechanical stop limits and make sure there is no

friction during gate travel.

 Do not use grease or other lubricants between rack and pinion

AXIOM SLIDING GATE OPENER MANUAL