Elsema iS2000 사용자 설명서 - 페이지 8

{카테고리_이름} Elsema iS2000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsema iS2000 8 페이지. High speed sliding gate opener elsema’s eclipse control card with gds operator
Elsema iS2000에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지)

페이지 인쇄

Maintenance Details

WARNING!
Failure to maintain equipment may result in injury or death and/or damage to property and
equipment.
If the product is not used and maintained in accordance with instructions or recommendations
listed in this User Manual, the warranty is negated.
Recommended maintenance to be performed on the operator and gate are as follows:-
Operator performs over 150 cycles a day
Operator performs between 20-150 cycles a day
Operator performs under 20 cycles a day
Date: ................................................................................
Site Name: ....................................................................................................................................
Site Address: .................................................................................................................................
Before commencing maintenance on the operator, isolate the electrical supply to ensure operator will
not run inadvertently.
Gate rolls freely when in manual ................................................................................... 
Gate wheels and guide rollers in good condition ........................................................... 
Gate stops are installed and in good condition, not loose ............................................. 
Gate rack is tight & correct clearances between pinion wheel & rack ........................... 
Gate track is not damaged ............................................................................................ 
Gate operator mounting bolts tight ................................................................................ 
No oil leaks from gearboxes .......................................................................................... 
Gearbox mounting bolts/nuts tight ................................................................................. 
Inside operator and control box clean ........................................................................... 
'Baygon' Surface Spray around operator and control box (not on electronics) ............. 
All electrical connections tight ....................................................................................... 
Limit Switches operate in appropriate positions ............................................................ 
External safety devices work effectively / cleaned ........................................................ 
Electromagnetic lock, if fitted, operates correctly and is clean ...................................... 
Wash down of control box and cover (particularly near corrosive/sea environments) .. 
General operation i.e. speed, auto close etc normal ..................................................... 
Comments.............................................................................................................................................
......................................................................................................................................................... ....
...............................................................................................................................................................
Service performed by:
.................................................................................................................................................
every 2 month
every 6 months
every 12 months