Elsist Pure 2000 사용 설명서 - 페이지 16

{카테고리_이름} Elsist Pure 2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsist Pure 2000 18 페이지. Single phase line interactive sinewave ups

페이지 인쇄

1. Troubleshooting

PURE 1000●2000●3000

LINE INTERACTIVE SINGLE-PHASE

SINEWAVE

6.1 Accessories

MODEL

Instruction manual

Software

RS232 cable

USB cable

Input cable (IEC)

Output cable

6.2 RS232 port

The present UPS provides a standard DB9 communication interface on the rear panel, the definition of the pins

is as

follows:

When connecting the UPS to the PC via RS232 cable, it is necessary to use the standard RS232 cable, the

exact connections of the cable are as follows:

6.3 Optional interface communication

1. USB communication interface

Install UPSilon2000 monitoring software supplied with the UPS. You can check directly the UPS

parameters from the PC. If both the RS232 cable and the USB cable are supplied, as only one is

possible to use, the USB cable is recommended.

2. Intelligent slot

The following boards can be installed in the UPS intelligent slot: SNMP board. The card can be

removed or inserted with the UPS ON. Depending on the needs of users you can use any of the listed

tabs.

2.1 SNMP card:

computer to monitor the power network and the status of the UPS

NOTE:

Remove the metal cover (Intelligent Slot) before installing the optional board.

The optional card slot can be used simultaneously with the RS232 port.

For the operating instructions of the SNMP card, refer to the instructions supplied with the card

Ver.00 09 March 2018

PURE 1000

2 (IEC)

1-4-6-7-8-9

CONNETTORE 1

(female)

serial port PC side

When you connect to the internet with the SNMP card, you communicate with the

PURE 2000

PURE 3000

●

2 (IEC)

1 Adapter High Current plug

DEFINITION

Not used

GND

CONNETTORE 2

(male)

serial port UPS side

remotely.