Elsner 10144 기술 설명, 설치 지침 - 페이지 12

{카테고리_이름} Elsner 10144에 대한 기술 설명, 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsner 10144 20 페이지. Radio control system
Elsner 10144에 대해서도 마찬가지입니다: 운영 (13 페이지)

4.3.4. Disassembling the wall bracket

Never expose the sensor to water (e.g. rain) or dust. This can damage the electronics.

Choose an installation position in the building where wind, rain and sun can be meas-

ured unhindered by the sensors. The weather station must not be installed underneath

any structural parts from which water can still drip onto the rain sensor after it has

stopped raining or snowing. The weather station must not be shaded by anything,

such as building structures or trees.

At least 60 cm of clearance must be left all round the weather station. This facilitates

correct wind speed measurement without eddies. The distance concurrently prevents

spray (raindrops hitting the device) or snow (snow penetration) from impairing the

measurement. It also does not allow birds to bite it.

Please take note that an extended awning does not shade the device from sun and

wind.

Temperature measurements can also be affected by external influences such as by

warming or cooling of the building structure on which the sensor is mounted, (sun-

light, heating or cold water pipes).

Solexa II Control • from software version 1.9

Version: 28.09.2016 • Technical changes and errors excepted.

Ill. 5

In the assembled state loosen the cover:

Using a small screwdriver lever carefully

in the groove. Remove the cover.

Installation/assembly