DataLocker Sentry K300 검토자 매뉴얼 - 페이지 7
{카테고리_이름} DataLocker Sentry K300에 대한 검토자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DataLocker Sentry K300 10 페이지. Encrypted keypad mssd with oled screen
DataLocker Sentry K300에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 배포 매뉴얼 (10 페이지)
페이지 인쇄8.
Device will show message "System data has been deleted." Press any key to
continue.
9.
The device will now power off automatically.
10. To reinitialize your Sentry K300 device, see Setting Up The Sentry K300 After Zeroize
below.
Setting Up The Sentry K300 After Zeroize
Setting up your device after a Zeroize command has been initiated is much like setting up a new
drive.
1.
Power on the device by pressing the P ower button.
2.
Device will ask "Initialize the device?" Select Y es , then press E nter .
Device will ask "All saved data will be deleted. Continue?" Select Y es , then press
3.
Enter .
4.
Device will ask "Warning! Verify to Continue?" Select Y es , then press E nter .
5.
The device will ask you to plug it in by showing an image of a plugged in device on the
screen.
W arning: Do not power off or unplug the device at this step. The device will move to
the next step automatically when it's finished initializing.
6.
Device will show the message "The initialized password is '1234567'". Unplug the
device and press any key to continue.
7.
Device will show the message "You must reformat the drive." Press any key to
continue.
8.
The device will power off and back on automatically. The password entry screen will
be displayed when it is finished restarting. Enter the default password of 1 234567 .
9.
Format the Sentry K300 on your system and it will then be ready for use. See
Formatting The Sentry K300 for more information.
Screensaver Mode
The device is programmed to turn off the screen after 10 seconds of either no use or the
waiting/connection screen. This prevents screen burn-in. To turn the screen back on, press any
key. This setting cannot be turned off.
Inactivity Mode
The device is programmed to power off after 60 seconds of inactivity. To power back on, press
the P ower button. This setting cannot be turned off.
Note: The device will not power off while connected to the computer. The screen may turn off
after 10 seconds to prevent screen burn-in, however, you can revive it by pressing any key.
Administrator Menu Screen Options
● Change Password: Change the administrator password.